To Start And Operate The Product In Cold Weather; To Operate The Product - Husqvarna P 524 Manual De Usuario

4. Turn the ignition key to the start position.
5. When the engine starts, immediately release the
ignition key to neutral position.
CAUTION: Do not run the starter for
more than 5 seconds at a time. If the
engine does not start, wait 15 seconds
before you try again.
6. Let the engine run at half throttle for 3-5 minutes
before you apply a heavy load.
CAUTION: If the warning lamp for oil
pressure comes on, stop the engine
immediately and refer to
on page 40 .
7. Push the throttle control to full throttle position.
CAUTION: To engage the blades when the
engine is at full speed causes strain on the
drive belts. Do not apply full throttle until the
cutting deck is lowered to the mow position.
242 - 003 -
To start and operate the product in cold
weather
•
•

To operate the product

1. Start the engine.
2. Press the parking brake pedal down and then
3. Carefully press down one of the speed pedals. The
Troubleshooting
4. Release the pedal to brake. To brake harder, press
If the engine does not start easily in cold weather,
turn the ignition key many times until the engine
starts. For P 524, make sure that the choke control is
moved fully rearward.
At temperatures lower than 0°C, let the product
become warm before you apply a heavy load.
Operate the product but do not engage the
equipment for a minimum of 10 minutes.
CAUTION: If the product is not warm
when you start to operate it, the
transmission can become damaged.
release it to disengage the parking brake.
speed increases the more the pedal is pressed
down. Use pedal (A) to move forward, and pedal (B)
to reverse.
A
B
down the other speed pedal.
19