Operation; Starting The Heater; Shutting Down The Heater; Cleaning, Care And Maintenance - Stiebel Eltron SunWarmth CIR 150-1 I Guía De Funcionamiento E Instalación

OPERATION

OPERATION
5. Operation
WARNING: Fire
Never leave the heater unattended during operation.
Heater must be installed on a timer switch. Unplug
120 V models or turn off circuit breaker(s) on 240 V
models if not in use.
5.1

Starting the heater

For 120 V models, plug the unit into a grounded electrical
»
outlet connected to a timer switch. Set timer switch for desired
operating time.
For 240 V models, turn on the circuit breaker(s) the unit is
»
connected to. Set timer switch for desired operating time.
5.2

Shutting down the heater

For 120 V models, turn off unit at timer switch and unplug the
»
unit's cord from the wall outlet.
For 240 V models, turn off unit at timer switch and power at the
»
circuit breaker panel.
6.

Cleaning, care and maintenance

WARNING:
!
Before cleaning, make sure the power has been turned
off at the circuit breaker panel or unplugged from the
wall outlet, and that the heating element of the heater
is cool. Ensure power remains disconnected during
entire installation. Failure to do so could result in
serious burns, electrocution, serious bodily injury, or
death.
6.1

Maintenance

Inspect the heater and cord prior to each use.
»
Clean any accumulation of dust or dirt from surfaces and in
»
particular from the refl ector and any air openings in the heater
body (see "6.2 Cleaning" on page 5).
Inspect the electrical cord and plug for damage or fraying:
»
— Do not operate the heater with a damaged cord or plug.
— Have damaged parts replaced by a qualifi ed electrician.
Any damaged parts or components must be repaired or replaced
»
prior to operation.
6.2

Cleaning

CAUTION: Fire
Never spray cleaning spray into the refl ector or any
openings.
Ensure that no moisture can enter the appliance.
— Before cleaning, disconnect the heater from the power supply
and allow to cool.
— Do not touch the heat lamp with your fi ngers - oil from your
skin will damage the lamp.
— To clean the heater surface, refl ector, and air inlets: Use only
a dry or damp cloth or low pressure air stream (computer
'duster' in a can).
WWW.STIEBEL-ELTRON-USA.COM
— Do not use any abrasive or caustic cleaning agents.
— Never immerse the appliance in water! Danger to life!
— If a heater is exposed to water beyond the intended use of
outdoor models, have a qualifi ed electrician inspect and
repair the heater prior to use.
— As part of regular maintenance, we recommend also having
the control components checked. The safety and control
components should be checked by a contractor no more than
ten years after commissioning.
7.

Safety

Only qualified contractors should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.
DANGER: Electrocution
If you mount the appliance on the wall, do so in such
a way that control equipment cannot be touched by a
person in the bath or shower.
CAUTION:
!
— Observe the minimum clearances to adjacent
object surfaces (see "9.5 Minimum required
clearances" on page 7).
— Never install the appliance directly below a wall
socket.
— Ensure that the power cable is not in contact with
any appliance components.
7.2

Instructions, standards and regulations

Observe all applicable national and regional regulations
and instructions.
8.

Appliance description

8.1

Standard delivery

— Heater unit
— Wall mounting bracket including fi xing screws, locking
washers and nut
SUNWARMTH ™ CIR INFRARED HEATER| 5