Stiebel Eltron SunWarmth CIR 150-1 I Guía De Funcionamiento E Instalación página 14

INSTALLATION
INSTALLATION
10 Slide top cover plates out each end of top side of heater:
11 Remove the center face plate:
The BOTTOM edge of the center Face Plate does not have a
»
lower lip
Insert a fi ne edged slot screw driver between the heater body
»
and the BOTTOM edge of the face plate
Pry the face plate from the heater body, and remove to storage:
»
12 Slide the end face plates out from each end of the heater:
14 |SUNWARMTH ™ CIR INFRARED HEATER
13 For this step, keep the heat lamp retainer clips in place at
each end of lamps. Heat lamp is fragile - use caution when
feeding wires through holes.
Carefully feed each lamp wire from the top of the heater through
»
the hole in the heater body so that the wire is inside the heater
body (same as the lamp):
14 Remove the heat lamp retainer clips both ends of lamps.
One clip at each end of heater
»
Two clips in the center of heater:
»
15 The heat lamp is very fragile - handle and assemble with
great care!
Carefully slide old heat lamp out of heater through rectangular
»
slot in end of refl ector.
Carefully install new heat lamp and clip in place.
»
Reverse steps above to reassemble the heater.
»
Take particular care not to damage the lamp at step 14 and
»
step 13:
WWW.STIEBEL-ELTRON-USA.COM