Battery Installation; Clock Setting - Rain Bird WTD 2900 Manual Del Propietário

WTD 2900
English
3. PROGRAMMATION

3.1 BATTERY INSTALLATION

Remove the battery holder cover (F) and install
batteries(Type AA-LR6 , not included in the box) inside.
Reinsert the battery holder into the timer and make sure
it is correctly locked.
You can now program your automatic watering.
Important:
- Use two(2)X 1,5 V alkaline batteries only (type AA - LR6)
- Do not use rechargeable batteries.
- Make sure batteries and battery holder are perfectly clean and dry.
- Make sure to respect the "-/+"orientation of batteries as shown on the white label.
- If your removes the batteries, the internal clock will lose the current time.
- To prevent corrosion, remove batteries when timer is not in use for longtime
periods.
- Reset clock and programs when batteries are removed for longer than one (1)
minute.

3.2 CLOCK SETTING

- Open the cover.
Note :
• Low Battery Test runs automatically.
• LO indicates defective batteries.
• When the day SU (SUNDAY) flashes, the batteries are OK.
• Begin programming.
• Close cover when finished.
To set-up automatic watering program, you need to define:
- The hour of the first irrigation run (start time)
- The duration of the watering run (watering run time)
- The frequency of watering (watering frequency)
The dial displays 12 :00 AM and the day SU (SUNDAY) flashes at the top of the dial.
- Press the MODE key to bring up the clock symbol. Press buttons firmly.
- Press the DAY/CYC key to display the current day.
- Press ENTER.
www.rainbird.eu
F
3