Rain Bird WTD 2900 Manual Del Propietário página 8

b ) Press HR/MIN to select the beginning hour water cycle.
- Press ENTER to save.
- Press HR/MIN again to select minutes ( Example : to start watering at 6:15 AM, select 6 AM
as the hour and 15 as the minutes).
- Press ENTER to save.
c ) Press HR/MIN to select the ending hour water cycle.
- Press ENTER to save.
- Press HR/MIN again to select minutes.
- Press ENTER to save.
- Repeat steps A- C to setup to 5 more daily schedules, if desired.
- When you have finished, press the MODE key to bring up the AUTO symbol.
Your timer is now programmed for automatic irrigation. You can now install it on your
faucet.
3.5 HOW TO MODIFY YOUR PROGRAM
- To change a program, press MODE to display the PROG symbol. The last cycle number used
will flash and schedule number appears.
- To change cycle number or cycle days, follow 3.3 Programming your automatic watering
& 3.4 Selecting watering start and stop times.
- To keep the same cycle, push ENTER twice. Schedule number will flash. Press SCH to select
the schedule number to change.
- Follow steps 3.4-b et 3.4c to make changes.
- When you have finished, press MODE to display the AUTO symbol.
3.6 TEMPORARY OVERRIDE
In AUTO mode, AUTO ON-OFF key will override current ON/OFF status. As timer reaches next
schedule start/stop time, it resumes normal operation
4. INSTALLATION
Do not open the LCD front panel during installation on the tap. Your Rain Bird WTD 2900 water
timer can be screwed directly onto a standard water faucet ( 3/4" or 21X 27 )
You can connect a hose at the bottom of the timer using the black quick coupling adapter (H),
provided in the box. Make sure that the black rubber seal inside the adapter is correctly positio-
ned before screwing it.
6
WTD 2900
English
www.rainbird.eu