Rain Bird WTD 2900 Manual Del Propietário página 6

The day stops flashing and the time starts to flash.
- Press HR/MIN to select current hour.
- Advance to correct hour with AM or PM in upper right corner.
- Press ENTER.
- Press HR/MIN to select current minute.
- Press ENTER.
Once the clock is set, the current day flashes.
3.3 PROGRAMMING YOUR AUTOMATIC WATERING
Table 1 ( see below) describes watering schedule options.
Only one cycle operates at one time.
- Choose from 8 programmed watering cycles (see Table 1).
- Choose watering days of the week in Cycle «-» or choose a cycle for watering
on interval days.
- Set up to 6 start/stop times for active Cycle.
Example : to water a new lawn in short periods daily, set Cycle 1 for every day with 6 start/stop
times.
STEP 1:START PROGRAMMATION
- Press MODE to display the PROG symbol. LCD displays empty schedule as --:--
- Press DAY/CYC to set watering frequency. The number on the right side of display next
to CYCLE will change.
- Press DAY/CYC for desired cycle.
- Press ENTER to save cycle content and confirm cycle mode.
If you selected Cycle 1-7, Go to step 3.4 Selecting watering start and stop times.
4
WTD 2900
English
www.rainbird.eu