Peg-Perego Pliko P3 Instrucciones De Uso página 18

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ IMPORTANT: read these instructions carefully and
keep them for future use. The child's safety could be
at risk if these instructions are not followed.
_ This item was designed for the transport of 1 child in
the seat and 1 one child standing on the rear footboard.
_ Do not use this item for a number of occupants greater
than that intended by the manufacturer.
_ This item is approved for children from birth up to
a weight of 15 kg in the seat. The rear footboard is
approved for the transport of a second child up to a
weight of 20 kg.
_ This item has been designed for use with the Peg
Perego Ganciomatic products: "Primo Viaggio" car seat
(0+ group) or Navetta (0 group).
_ Before use check that the Peg Perego Ganciomatic
products are correctly fixed to the item.
_ The assembly and preparation of the item must be
carried out by an adult.
_ Do not use this item if there are parts missing or signs
of breakage.
_ Always use the five point harness; always use the harness
crotch strap in combination with the waist strap.
_ It may be dangerous to leave your child unattended.
_ Always apply the brake when stationary.
_ Before use check that all the attachment mechanisms
are correctly engaged.
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest).
_ Any weights hanging on the handlebar or handles could
make the item unstable; follow the manufacturer's
instructions as regards the maximum loads transportable.
_ The front bar is not designed to support the child's
weight. It is not designed to keep the child in the seat
and does not substitute for the waist belt.
_ Do not load the baskets over 5 kg. Do not put weight in
the cup holder in excess of those indicated on the cup
holders themselves and never hot drinks. Do not put loads
of more than 0.2 kg in the hood pockets (if present).
_ Do not use the item near to stairs or steps, heat sources,
naked flames or dangerous objects within reach of the child.
_ The use of accessories not approved by the
manufacturer could be dangerous.
_ This item is not suitable for jogging or roller skating.
_ Apply the brake when loading or unloading children.
_ WARNING: Do not add a mattress.
COMPONENTS OF THE ITEM
Check the contents of the packaging and for any
complaints please contact the After-Sales Service
- The COMPLETE Pliko P3 stroller is composed of:
2 swivel or locking front wheels, 2 rear wheels with brake
cable, basket, cup holder, front bar, hood, cover, rain canopy.
PlikoP3_FI001001I72.indd 18
- The CLASSICAL Pliko P3 stroller is composed of:
2 swivel or locking front wheels, 2 rear wheels with
brake cable, basket, cup holder, front bar, hood.
These items are numbered progressively.
INSTRUCTIONS FOR USE
1• OPENING: before opening the chassis remove the two
safety caps from the hooks, otherwise it will be impossible
to open it correctly (Fig.a). To open the chassis, pull the
two levers on the handlebars upwards (Fig.b);
2• at the same time, lift the chassis and it will open
automatically (Fig.c). To make sure that the stroller is
correctly open, check the two side hooks (Fig.d).
3• ASSEMBLING: to mount the front wheels, lower lever A
and slip wheel B on until it clicks into place.
4• To assemble the rear wheels connected by the brake
cable, carefully distinguish the left wheel from the right
wheel to fasten the two wheels correctly. The left wheel
features a rib on the wheel tube and one on the chassis
(Fig.a). Join them (Fig.b) and check that they are firmly
fastened until they click (Fig.c).
5• BASKET: to mount the basket, slip the loops over the
front hooks A and rear hooks B and C. The figure shows
the attached basket.
6• CUP HOLDER: The cup holder can be placed on left or
right side of the stroller through the hook fitted on both
sides of the chassis. To fit the cup holder, click it on (Fig.a).
ADJUSTING THE HANDLEBARS: The height of the two
handlebars can be adjusted to two positions. For the
higher position, press the button while pulling the
handlebars upwards. To lower it, do the opposite (Fig.b).
7• BRAKE: to set the brakes on the stroller, lower the levers
on the rear wheels with your foot (Fig.a). To release the
brakes, lift the lever.
Always set the brakes when the stroller is not moving.
SWIVEL WHEELS: to swivel the front wheels lower the
levers as shown in arrow 1 (Fig.b). To set the wheels on
stationary, lift the lever as shown in arrow 2.
GANCIOMATIC SYSTEM
Ganciomatic System is a quick and practical way to
fasten the Navetta or PrimoViaggio, which are both
equipped with the Ganciomatic system, to the Pliko P3.
8• GANCIOMATIC HOOKS FOR THE STROLLER:
the Ganciomatic connectors on the chassis, pull the
lever outwards and at the same time swivel the two
connectors upwards until they click (fig_a).
To lower the stroller Ganciomatic hooks, pull the lever
outwards while turning the hooks downwards (fig_b).
9• PLIKO P3 + Navetta : to fasten the Navetta to the
stroller, proceed as follows (fig_a):
- set the brakes on the stroller;
- lower the stroller backrest completely;
- raise the stroller Ganciomatic hooks;
- remove the front bar and insert the caps provided to
close the stroller armrests;
- raise the footrest to its highest position;
- hold the Navetta by its handlebar;
- place the Navetta on the Ganciomatic hooks on the
stroller, keeping the head of the bassinet unit on the
opposite side from the stroller handlebars;
- 18 -
to raise
15-02-2010 9:45:47