Layout And Items Supplied - EINHELL TC-BD 350 Manual De Instrucciones

working with machine tools. Ensure that you wear
safety goggles. Not doing so could result in eye
injury.
Keep your work area neat and tidy
Disorder in the work area can easily lead to acci-
dents. Do not leave any tools, objects, or cable in
the direct vicinity of the work area, as this poses
a tripping hazard! Ensure that there is suffi cient
lighting.
Watch out for other persons
Watch out for other persons (especially children)
when using the device, and keep them away from
your work area. Do not let anyone touch the de-
vice or the power cable.
Store the tools in a safe location
Store unused devices in a dry, locked location
that is out of the reach of children.
Avoid overloading the device
Operate the device only within the specifi ed out-
put range. Do not use any low-powered machines
for heavy duty work. Do not use tools to perform
work for which they were not intended.
Maintain a steady foothold
Ensure that you maintain a steady foothold while
working. Avoid abnormal body positions and al-
ways keep your balance.
Pull out the mains plug
Pull out the mains plug when not using the tool,
prior to maintenance, and when changing the drill
bit.
Pull out the power plug.
Ensure that the mains connection is protected by
at least a 10 A-rated fuse.
Avoid unintentional start-up
Ensure that switch is turned off when plugging the
plug into the socket.
Keep an eye on your work
Always keep an eye on your machine and the
object you are working on. Never use the machine
when you are not concentrating or are distracted.
Never use the machine when you are under the
infl uence of alcohol or are taking medication.
Check the tool for damage
Before using the tool, safety devices and any
slightly damaged parts must be carefully checked
Anl_SA_TC_BD_350_SPK8.indb 30 Anl_SA_TC_BD_350_SPK8.indb 30
GB
to ensure that they are in good working order. Vi-
sually examine the tool's power cable on a regular
basis. All parts must be correctly assembled and
meet all the conditions required to ensure proper
operation. Unless otherwise specifi ed in the ope-
rating instructions, any damaged safety devices
and parts must be properly repaired or replaced
by a professionally recognized workshop. Never
use tools with defective On/Off switches.
Warning! Using any plug-in tools and accesso-
ries other than those specifi ed in these operating
instructions can lead to injury.
Now, please read and follow all steps and
procedures included in the operating instruc-
tions.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Machine base
2. Pillar
3. Fixing screw
4. Drill table
5. Clamping screw
6. Machine head
7. V-belt
8. Motor
9. Grip knobs
10. Scroll chuck
11. Spindle
12. Mounting holes
13. Folding chip guard
14. Depth stop
15. Tightening screw
16. Screw
17. Clamping screw
18. ON switch
19. OFF switch
20. Grub screw
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
•
Open the packaging and take out the equip-
- 30 -
20.05.2019 14:27:59 20.05.2019 14:27:59