Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LERBAKKEN 10, 8410 RØNDE DENMARK
9202Axx Installation:
Non Hazardous area or Zone 2
Supply: 19.2 – 31.2 VDC
(terminal 31,32,33,34)
(terminal 91,92,93,94,95)
Input: Namur sensor, Contact Sensor, Switch
CH1 (terminal 41,42,43,44)
CH2 (terminal 51,52,53,54)
Output:
Terminal CH1(11,12) CH2(13,14)
Digital output:
Voltage max.
Current max.
Terminal CH1(11,12) CH2(13,14)
Relay output:
Voltage max.
Power max.
Current max.
For installation in Zone 2, the module shall be installed in an enclosure in type of protection Ex n or Ex e,
providing a degree of protection of at least IP54. Cable entry devices and blanking elements shall fulfill the
same requirements.
For installation on Power Rail in Zone 2, only Power Rail type 9400 supplied by Power Control Unit type 9410
(Type Examination Certificate IECEx 08.0052X) is allowed.
For Installation in Zone 2 / Division 2 the following must be observed.
The 4501 programming module is to be used solely with PR electronics modules. It is important that the
module is undamaged and has not been altered or modified in any way. Only 4501 modules free of dust and
moisture shall be installed.
Revision date:
2016-04-07
26
CH1
44
+
43
42
-
41
+
CH2
54
53
52
-
51
91 92 93 94 95
Power
Rail
NPN output:
30 VDC
80 mA
Non Hazardous location
250 VAC / 30 VDC
500 VA / 60 W
2 AAC / 2 ADC
Version Revision
V5 R0
9202 - Versión del producto 9202-003
-20 ≤ Ta ≤ 60ºC
4501
34
33
32
31
14
13
12
11
9202
Zone 2 installation
32 V AC / 30 VDC
64 VA / 60 W
2 AAC / 2 ADC
Prepared by:
PB
9202QI01
Page:
3/3
Publicidad
Tabla de contenido
