Dispersion Tool S 50 Tt - W 40 Tt - IKA ULTRA-TURRAX T 50 basic Instrucciones De Manejo

Spare parts:
Sterilization :
After cleaning the dispersion tools the method A) is suitable for this disper-
sion tool. The methods B) and C) must not be used otherwise the ball bea-
ring and the friction ring seal will be destroyed.
(See Maintenance, cleaning and sterilization of dispersion tools).

Dispersion tool S 50 TT - W 40 TT

Overview (Fig. 3)
This dispersion tool meets all requirements for corrosion-resistance. The
parts coming into contact with the product are made from glass-reinforced
PTFE and titanium.
The PTFE components (shaft tube, stator and bearing bushing) are
relatively soft and thus permit operations in the liquid/liquid and
liquid/gaseous ranges.
Because PTFE softens at high temperatures a maximum medium
temperature of 100°C must not be exceeded.
Hard, abradant and abrasive materials must not be processed.
082006
Item Designation
2 Grooved pin
4 Deep-groove ball bushing
5 Circlip
8 Friction ring seal assembly
12 Shaft tube
2001 Rotary shaft assembly
3007 Spring
3008 Flat seal
3009 Round seal
3010 Pin
3011 Round seal
High flow speeds (up to 20 m/s) result in chemical corrosion of the titanium
components when used in high-oxidizing acids.
The dispersion tool can be disassembled for cleaning as described below:
• Unscrew the rotor (15) from the rotary shaft (9) using the generator
and shaft wrenches included in the tool kit. The generator wrench is
used to hold the rotor while unscrewing it by turning the shaft from
above with the shaft wrench.
• Unscrew the stator (14) from the shaft (10) (left-hand thread).
Insert the cross pin (3mm) of the shaft wrench into the slot on the
end face of the shaft tube. The stator can now be unscrewed by tur-
ning it in the clockwise direction with the generator wrench.
• Pull the rotary shaft (9) down and out of the shaft tube. The com-
ponents (7; 11 und 12) threaded on to the shaft can simply be pul-
led off.
• The bearing bushing (7) muust be replaced if it is worn.
Reassamble the dispersion tool in the reverse sequence. When assam-
bling ensure that the bearing bushing is correctly installed. The stator
must only be screwed on to the shaft tube by hand.
Spare parts : Item
2
7
8
10
12
13
14
15
2001
Designation
Grooved pin
PTFE bearing bushing
Adapter
Shaft tube
Bushing
Shaft sleeve
Stator
Rotor
Rotary shaft assembly
19