Rear Display - Pioneer AVH-Z9200DAB Manual De Instalación

CAUTION
Be sure to use a mini-jack AV cable (sold
separately) for wiring. If you use other
cables, the wiring position might differ
resulting in disturbed images and sounds.
L : Left audio (White)
R : Right audio (Red)
V : Video (Yellow)
G : Earth
Using an HDMI input
This product
HDMI port
High Speed HDMI™ Cable (sold
separately)
HDMI device (sold separately)
NOTE
When you connect the High Speed HDMI™
Cable, use the lock tie to fix it securely
(page 7).
Securing the High
Speed HDMI™
Be sure to fix the High Speed HDMI™ Cable
with the lock tie, when you connect the
external device with the High Speed
HDMI™ Cable.
1
Insert the High Speed HDMI™ Cable
into the HDMI port.
2
Wrap the lock tie around the hook
above the HDMI port and the High
Speed HDMI™ Cable, and then tighten
it to secure the High Speed HDMI™
Cable.
Hook
Lock tie
High Speed HDMI™ Cable
CAUTION
Do not tighten up the lock tie more than
necessary.

Rear display

This product
Rear audio output (R. AUDIO OUT)
Yellow (REAR MONITOR OUTPUT) 30
cm
Mini pin plug cable (sold separately)
RCA cables (sold separately)
To audio input
To video input
Rear display with RCA input jacks (sold
separately)
WARNING
NEVER install the rear display in a location
that enables the driver to watch the video
source while driving.
This product's rear video output is for
connection of a display to enable
passengers in the rear seats to watch the
video source.
En
7