Electrical Connections Checkout (N.o. Systems) - Haldex RF5910XX Manual De Instalación

J. Connect one lead of the N.O. Freon Pressure Switch to
Red lead connecting the N.C. Solenoid Valve to terminal of
the N.O. Thermal Switch.
K. Connect other lead of the N.O. Freon Pressure Switch to
vehicle accessory or ignition terminal.
L. Connect one lead of Air Pressure Switch to vehicle ground.
M. Connect other lead of Air Pressure Switch to one terminal
of Indicator Light.
N. Connect other terminal of Indicator Light to vehicle
accessory or ignition terminal.
O. Connect battery cables to battery.
ELECTRICAL CONNECTIONS CHECKOUT
N.O. Electrical Control System
A. With engine temperature below Thermal Switch setting, turn
on ignition and build up air pressure.
B. Install jumper wire between terminals of N.O. Thermal
Switch; this will engage Fan Clutch.
Keep hands and tools clear of fan blades. Fan
Clutch can engage without warning.
C. Remove jumper wire to exhaust air and disengage fan
clutch.
D. Repeat the above Steps for the N.O. Freon Pressure Switch.
E. Set Manual Toggle Switch to "ON" position; this will engage
Fan Clutch. Indicator Light will light when Fan Clutch is
engaged. If Indicator Light fails to light, check bulb and
Indicator Light's ground connection.
"OFF" position is for automatic operation, "ON"
position is for continuous operation.
WARNING
NOTE
9