Cutting Blades - Cub Cadet LTX1046 Manual Del Usuario

5. Looking at the cutting deck from the left side of the tractor,
locate the deck support pin on the rear left side of the
deck.
6. Pull the deck support pin outward to release the deck from
the deck lift arm. See Figure 7-4.
Deck Lift Arm
Figure 7-4
7. Repeat the above steps on the tractor's right side.
8. Move the deck lift lever into the top notch to raise the deck
lift arms up and out of the way.
10. Remove the cotter pin from the end of the stabilizer rod
and slide the stabilizer out of the hanger bracket on the
deck. See Figure 7-5.
Figure 7-5
11. Gently slide the cutting deck (from the right side) out from
underneath the tractor.
Deck Support Pin

Cutting Blades

WARNING!
Shut the engine off and remove
ignition key before removing the cutting blade(s) for
sharpening or replacement. Protect your hands by
using heavy gloves when grasping the blade
WARNING!
Periodically inspect the blade and/or
spindle for cracks or damage, especially after you've
struck a foreign object. Do not operate the machine
until damaged components are replaced.
To remove the blades, proceed as follows.
1. Remove the deck from beneath the tractor, (refer to
Cutting Deck Removal earlier in this section) then gently
flip the deck over to expose its underside.
2. Place a block of wood between the center deck housing
baffle and the cutting blade to act as a stabilizer.
See Figure 7-6.
3. Remove the flange lock nut that secures the blade to the
spindle assembly. See Figure 7-6.
Flange Lock Nut
Figure 7-6
Block of Wood
S 7 — S 25
ection ervice