Cub Cadet LTX1046 Manual Del Usuario página 28

5. On 46" Decks: Install the new belt by routing it around the
two outer spindle pulleys as shown in Figure 7-10.
Deck Idler
Pulleys
6. Then route the belt around the two deck idler pulleys as
show in Figure 7-10.
7. Tighten the left deck idler pulley and belt keeper loosened
earlier.
CAUTION:
result in serious damage to your tractor's PTO
system.
8. On 50" Decks: Install the new belt by routing it around the
two outer spindle pulleys, then around the front spindle
pulley as shown in Figure 7-11.
Deck Idler
Pulleys
9. Then route the belt around the two deck idler pulleys as
shown in Figure 7-11.
28 S 7— S
ection ervice
Outer Spindle
Pulleys
Figure 7-10
Failure to reinstall the belt keeper may
Front Spindle
Pulley
Outer Spindle
Pulleys
Figure 7-11
10. Tighten the left deck idler pulley and belt keeper loosened
earlier.
CAUTION:
Failure to properly reinstall the belt
keeper rod may result in serious damage to your
tractor's PTO system.
On 46" & 50" Decks
11. Remount the belt covers removed earlier.
12. Re-install the deck making sure the belt remains routed
around the pulleys as instructed.
13. Pull the right side of the belt and place the narrow V side of
the belt into the PTO pulley. See Figure 7-12.
Figure 7-12
14. While holding the belt and pulley together, rotate the
pulley to the left. Continue holding and rotating the pulley
and belt until the belt is fully rolled into the PTO pulley.
PTO Belt
Rotate
Pulley