English
Keep the „S"
button pressed for at least 2 seconds until the yellow LED
The flowrate for the FIRST 12 hours must be adjusted within 10 seconds (see chapter 3A/3B).
Two flowrates in a 12-hours alternation are now activated.
B
De-activation of 12 hour bio function:
Two flowrates in a 12-hour alternation are activated.
Keep the „S"
button pressed for at least 2 seconds until the yellow
Shortly press the „S" button
The 12-hour bio function is now de-activated.
The filter returns to the previously set mode (Fig.: factory settings).
6. Switching on / off the FLOW FUNCTION
A
Activation of the flow function:
Automatic mode: 1 to 6 green LEDs
Keep the „S"
button pressed for at least 2 seconds until the yellow
Shortly simultaneously press the „+"
An alternation between the maximum and minimum flowrate is now activated.
2 LEDs
are illuminated sequentially between min. and max.
B
De-activation of the flow function:
An alternation between the maximum and minimum flowrate is now activated.
2 LEDs
are illuminated sequentially between min. and max.
Keep the „S"
button pressed for at least 2 seconds until the yellow
Shortly press the „S" button
The stream function is now de-activated.
The filter returns to the previously set mode (Fig.: factory settings).
7. Switching on / off the MANUAL MODE
A
Activation of the manual mode:
Automatic mode: 1 to 6 green LEDs
Keep the „S"
button pressed for at least 2 seconds until the yellow LED
Shortly press the „S" button
The manual mode is now activated. Only the yellow LED
The automatic re-adjustment and the service indicator are de-activated.
B
De-activation of the manual mode:
The manual mode is activated. Only the yellow LED
Keep the „S"
button pressed for at least 2 seconds until the yellow
Shortly press the „S" button
The manual mode is now de-activated. The filter returns to the previously set mode (Fig.: factory settings).
8. Resetting to FACTORY SETTINGS
Simultaneously presse the „S"
The pump and the electronics switch off for approx. 5 seconds an the system re-calibrates itself (see chapter 4).
Automatic mode (factory setting = 6 green LEDs
again within 10 seconds.
are illuminated (Fig.: factory settings).
and „–"
buttons once within 10 seconds.
again within 10 seconds.
are illuminated (Fig.: factory settings).
again within 10 seconds.
is illuminated.
is illuminated.
again within 10 seconds.
, „+"
and „–"
buttons for at least 2 seconds.
are illuminated).
7
starts to flash.
LED starts to flash.
LED starts to flash.
LED starts to flash.
starts to flash.
LED starts to flash.
manual
mode