Installation Method - mundoclima H6M Serie Manual De Instalación Y De Usario

2. Installation accessory
2.1 Select the installation location
Don't install at the place where cover with heavy oil, vapor or sulfureted gas,
otherwise, this product would be deformed that would lead to system malfunction.
2.2 Preparation before installation
1. Please confirm that all the following parts you have been supply.
1R 1DPH
:LUH FRQWUROOHU
1
Installation and owner's manual
2
Screws
3
:DOO SOXJV
4
5
Screws
3ODVWLF VFUHZ EDUV
6
Battery
7
The connective wires group
8
2. Please filed install the following accessory.
1R
1DPH
1
6ZLWFK ER[
:LULQJ 7XEH ,QVXODWLQJ
2
6OHHYH DQG 7LJKWHQLQJ
6FUHZ
Precaution of install the wire controller
1. This manual provides the installation method of wire controller. Please refer to the
wiring diagram of this installation manual to wire the wire controller with indoor unit.
2. The wire controller working in low voltage loop circuit. Forbid to directly contact the
cable of 220Vcommercial electricity or of 380V high voltage, and don't wire this kind
of wire in the said loop; wiring clearance between configured tubes should at the
range of 300~500 or above.
3. The Shielded wire of the wire controller must be grounded reliable.
4. Upon finish the wire controller connection, do not employed tramegger to detect the
insulation.

3. Installation method

1. Dimensions
120mm
123mm
4W\ 5HPDUNV
3 0; )RU 0RXQWLQJ RQ WKH :DOO
)RU 0RXQWLQJ RQ WKH :DOO
2 0; )RU 0RXQWLQJ RQ VZLWFK ER[
)RU IL[LQJ RQ VZLWFK ER[
2SWLRQDO
6SHFLILFDWLRQ
4W\ HPEHGHG
RQO\ IRU UHIHUHQFH
LQWR ZDOO
1
1
18.5mm
46mm
62mm
Fig 3-1
98
5HPDUNV
83.5mm