Charge-To-Discharge & Discharge-To-Charge Cycle Nimh/Nicd Batteries; Pb (Lead-Sulphuric Acid) Battery Program; Charging Pb Batteries - Medion Venom Manual De Funcionamiento

NiMH / NiCD BATTERY PROGRAMS (CONTINUED)
CYCLING NiCD/NiMH BATTERIES
This program can be used to charge then discharge, or discharge and then charge
At the end of the process you can view the charged or discharged capacity of the
battery. Press the INC or DEC button and the screen will display the results of each
cycle.
PB (LEAD ACID) BATTERY PROGRAM
1.)
2.)
Change the parameters of charging by pressing the Start/Enter button to make it
flash. Then change the value with the INC or DEC button. The value will be stored
by pressing Start/Enter button once.
0668
NiCD/NiMH batteries. Set the sequence on the left
and the number of cycles on the right. You can use
this function for balancing, refreshing or breaking in
a battery. To avoid excess heat build up in the battery
during each charge or discharge sequence, there is a
"waste time" that can be set in the User Set program
menu, which is a brief cool off period. Cycle sequences
can range from 1-5.
To stop the process, press Batt type/Stop button once.
You can alter the discharge or charge current by
pressing Start/Enter button once during the process,
using the INC or DEC to change the setting, and the
Start/Enter button to save the setting. An audible alarm
will sound indicating the end of the cycle sequence.
CHARGING PB (LEAD ACID) BATTERY
This program is for charging Pb (lead acid)
batteries with a nominal voltage from 2-24V.
Pb batteries are totally different from NiCD
or NiMH batteries. They can only deliver
relatively low current compared to their
capacity, and similar restrictions apply to
charging. The optimal charge current will be
1/10 of the capacity. Pb batteries must not be
charged rapidly. Always follow the instructions
supplied by the battery manufacturer.
[ 17 ]