Balance Socket - Medion Venom Manual De Funcionamiento

BALANCE SOCKET

The balance wire attached to the battery must be connected to the charger's
balancing port. Take care to maintain correct polarity!
(Wiring diagram: see below.)
This photo shows the correct way to connect your battery to the Medion Dual 10
Amp Charger while charging in the balance charge program mode only.
NOTE:
The balance socket is a diagnostic connection only. Battery discharge leads
must be connected to allow for a proper charge connection.
Balance socket connection left
Balance socket connection right
WARNING
Failure to connect as shown in this photo will damage this charger.
To avoid short circuit between the charge lead, always connect the charge
cable to the charger first, then connect the battery. Reverse the sequence when
disconnecting.
0668
[ 7 ]