Manual Settings; Time Setting; Alarm Settings - TFA Dostmann ELLYPSE Instrucciones De Uso

TFA_No. 60.2551_Anleitung_04_20 02.04.2020
ELLYPSE – Radio-controlled alarm clock with USB charging function
Therefore, please note the following steps:
• The recommended distance to any interfering sources like computer screens or TV sets is at least 1.5 - 2 meters.
• Within concrete walls (reinforced with steel) such as basements, the received signal is naturally weakened. In extreme
cases, please place the unit close to a window to improve reception.
• During night-time, the atmospheric interference is usually less severe and reception is possible in most cases. A single
daily reception is adequate to keep the accuracy deviation under 1 second.
7. Operation

7.1 Manual settings

• Important: The device cannot be operated during the DCF time-signal reception.
• Press and hold the UP or DOWN button in setting mode for fast mode.
• The device will automatically quit the setting mode if no button is pressed for 20 seconds.

7.1.1 Time setting

• Press and hold the MODE button in normal mode for three seconds.
• The time zone (00 - default) will be flashing. Press the UP or DOWN button to make the time zone correction (+1/-1).
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is different from
the DCF time (e.g. +1=one hour plus).
• Press the MODE button again and you can adjust the hours and the minutes with the UP or DOWN button.
26
15:04 Uhr Seite 14
– 26 –
ELLYPSE – Radio-controlled alarm clock with USB charging function
• Confirm the setting with the MODE button.
• The manually set time is overwritten once the DCF time signal is successfully received.
7.1.2 12 and 24 hours display
• Press DOWN button in normal mode to choose 12 HR or 24 HR system.
• In 12 HR system PM appears after 12 h on the display.

7.2 Alarm settings

• Press the MODE button in normal mode to enter the alarm mode.
• AL and 06:00 (default) or the last adjusted alarm time appear on the display.
• Press and hold the MODE button for three seconds to enter the setting mode.
• The alarm symbol will appear on the display and the alarm is activated. The hour digits flash.
• Press the UP or DOWN button to set the desired time.
• Confirm with the MODE button.
• Set the minutes in the same way.
• Confirm with the MODE button.
• 5 (default) or the last adjusted snooze interval appear on the display.
• Press the UP or DOWN button to set the desired time duration (5 to 60 minutes).
– 27 – 27