Display Light; Battery Replacement - TFA Dostmann ELLYPSE Instrucciones De Uso

TFA_No. 60.2551_Anleitung_04_20 02.04.2020
ELLYPSE – Radio-controlled alarm clock with USB charging function
• Confirm with the MODE button.
• To activate and deactivate the alarm function press the AL button in normal mode.
• The alarm symbol appears/disappears on the display.
• When the alarm is activated, the alarm starts to ring when the set alarm time is reached.
• Press any button (except SNOOZE) and the alarm will stop.
• If the alarm is not stopped manually, the ascending alarm tone automatically turns off after two minutes and it will be
reactivated at the same set time on the following day.
• The alarm symbol remains on the display.
• When the alarm rings, press the SNOOZE sensor button briefly and the snooze function is activated.
• Once the snooze function is activated, the snooze symbol will be flashing on the display.
• The alarm will be interrupted for the set time.

7.3 Display light

• You can select between 3 levels of brightness with the SNOOZE sensor button (HIGH/LOW/OFF).
• In addition, the brightness can be adjusted continuously to the desired level with the LIGHT dial (on level HIGH and LOW).
7.4 Volume
• The alarm volume can be adjusted continuously to the desired level with the VOL dial.
28
15:04 Uhr Seite 15
– 28 –
ELLYPSE – Radio-controlled alarm clock with USB charging function
7.5 Charging function
• Plug the USB cable (not included) into the USB port on the alarm clock and connect the other end to your mobile device.
Make sure that the USB charging function is suitable for your mobile device (charging current 1A).
• Do not apply excessive force when connecting a USB cable. The USB plug fits only one way into the USB port.
8. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• Remove the batteries if the device will not be used for an extended period of time.
• Keep the device in a dry place.

8.1 Battery replacement

• Open the battery compartment and insert two new AAA 1.5 V batteries, polarity as illustrated.
• Close the battery compartment again.
9. Troubleshooting
Problem Solution
➜ Connect the device to the power adapter
No or weak display
➜ Check the power adapter
– 29 – 29