Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
High Speed Cutter, Engraving
Cutters and Drill Bits
High speed cutters are used in carving,
cutting and slotting wood, plastics and
soft metals. Engraving cutters are used
for intricate work on ceramics, wood
carvings and jewelry and drill bits are
used to punch holes in just about any
type of wood and wood composites.
Different sized drill bits will require the
appropriate collet to be used.
Cutters and Drill Bits
Material
Stone
Steel
Aluminum, Brass
Plastic
Abrasive Discs
These abrasive discs are used for slicing
cutting off and similar operations.
Abrasive Discs
Material
Steel
Aluminum, Brass
Plastic
10
ASSEMBLY & OPERATION
Speed Setting
6
3
6
1
Speed Setting
5
3
5
ROTARY TOOL MAINTENANCE
WARNING!
Preventive maintenance performed
by unauthorized personnel may
result in misplacing of internal
wires and components which could
cause serious injury and will void
warranty.
Cleaning
To avoid accidents always disconnect
the tool from the power source
before cleaning or performing any
maintenance. The tool is most effectively
cleaned using compressed air. Ventilation
openings and switch levers must be kept
clean and free of foreign matter.
Certain cleaning agents and solvents
damage plastic parts, such as gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household
detergents which contain amonia.
Carbon Brushes (Fig.6)
The brushes (A) Fig.6 and commutator
in your tool have been engineered for
many hours of dependable service. To
maintain peak efficiency of the motor,
we recommend that the brushed be
inspected after 50-60 hours of use. If the
carbon brushes are less than 1/8" long,
replacement brushes are needed.
!
Publicidad
Tabla de contenido
