Force PT113001 Manual De Operador página 6

SPECIFIC SAFETY INSTRUCTIONS FOR ROTARY TOOLS
1. Accessories must be rated for at
least the speed recommended on
the tool nameplate. Wheels and
other accessories running over rated
speed can fly apart and cause injury.
2. Do not operate the flexible shaft
with sharp bend. Over-bending the
shaft can generate excessive heat
on the jacket or hand piece. The
recommended minimum is 6" radius.
3. After changing the bits or making
any adjustments, make sure
the collet nut and any other
adjustment devices are securely
tightened. Loose adjustment device
can unexpectedly shift, causing loss
of control; loose rotating components
will be violently thrown.
4. Do not use a grinding wheel
that may be damaged. Inspect all
grinding wheels and tips before use.
Fragments from a wheel that bursts
during operation will fly away at
great velocity possibly striking you or
bystanders.
5. Use clamps to support work piece
whenever practical. Never hold a
SAFETY SYMBOLS
Please read all of the safety and operating instructions carefully before using
Please read all of the safety and operating instructions carefully before using
this tool. Please pay particular attention to all sections of this Operator's
this tool. Please pay particular attention to all sections of this Operator's
Manual that carry warning symbols and notices.
Manual that carry warning symbols and notices.
n
0
V~
A
Hz
.../min
6
SAFETY SYMBOLS
SAFETY SYMBOLS
Observe caution and safety notes!
No-load speed.
Voltage
Protect electrical power tool from moisture!
Check that the device, power cord and plug are in good condition!
Safety class II
Dispose of packaging and appliance in an environmentally friendly way!
Amperes
Hertz
Revolutions or reciprocation per minute
small work piece in one hand and the
tool in the other hand while in use.
Clamping a small work piece allows
you to use both hands to control
the tool. Allow for sufficient space,
at least 6", between your hand and
the spinning bit. When using the
cut-off wheels, high-speed cutters
or tungsten carbide cutters, always
have the work securely clamped.
Never attempt to hold work with
one hand while using any of these
accessories.
6. Never start the tool when the bit
is engaged in the material. The bit
cutting edge may grab the material
causing loss of control of the cutter.
7. If the work piece or bit becomes
jammed or bogged down, turn the
tool "OFF" by the switch. Wait for
moving parts to stop and unplug the
tool, then work to free the jammed
material.
8. Do not grind or sand near
flammable materials. Sparks
from the wheel could ignite these
materials.