Force PT113001 Manual De Operador página 3

GENERAL POWER TOOL SAFETY WARNINGS
4. Power Tool Use and Care
a) Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it
was designed.
b) Do not use the power tool if the
switch does not turn it on and off. Any
power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
c) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands
of untrained users.
e) Maintain power tools. Check for
PARTICULAR SAFETY WARNINGS FOR ROTARY TOOL
a) Hold power tools by insulated
gripping surfaces when performing
an operation where the cutting tool
may contact hidden wiring or its own
cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and
shock the operator.
b) Use clamps or another practical way
to secure and support the work piece
to a stable platform. Holding the work
by hand or against your body leaves it
unstable and may lead to loss of control.
Safety instructions for all
operations
WARNING!
Common for Grinding, Sanding,
Polishing or Abrasive Cutting-Off
Operations:
a) This power tool is intended to
function as a grinder, sander,
polisher or cut-off tool. Read all safety
warnings, instructions, illustrations and
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation.
If damaged, have the power tool repaired
before use. Many accidents are caused
by poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5. Service
a) Have your power tool serviced by
a qualified repairperson using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
specifications provided with this power
tool. Failure to follow all instructions listed
below may result in electric shock, fire
and/or serious injury.
b) Operations such as wire brushing are
not recommended to be performed
with this power tool. Operations for
which the power tool was not designed
may create a hazard and cause personal
injury.
c) Do not use accessories, which
are not specifically designed
and recommended by the tool
manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
d) The rated speed of the accessory
must be at least equal to the maximum
speed marked on the power tool.
!
Accessories running faster than their
RATED SPEED can break and fly apart.
e) The outside diameter and the
thickness of your accessory must
be within the capacity rating of
your power tool. Incorrectly sized
accessories cannot be adequately
3