Features; Operation Instructions - Surtek LB521B Manual De Usuario Y Garantía

Align the inside arrow mark of the sanding
belt with the revolving direction of the drive
pulley.
Sanding by applying impact and cutting by
side of belt contact should be avoided.
Be careful of sanding sparks.
After operation sweep the sanding dust from
the dust bag to avoid serious accidents.
Don't use water, or oil as lubricant.
Ascertain that the sanding workpiece contains
neither nails nor other harmful foreign matter.
Sanding glass fiber is not recommended.
After operation, blow away the dust on the
belt and the pulleys.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
4
1. ON/OFF SWITCH.
2. LOCK-ON BUTTON.
3. DUST MANAGEMENT BAG.
4. PULLEY ADJUSTMENT KNOB.
UNPACKING
This product has been shipped completely as-
sembled, except cutting blade.
1. Carefully remove the tool and the acces-
sories from the box. Make sure that all items
listed in the packing list are included.
2. Inspect the tool carefully to make sure that
no breakage or damage occurred during ship-
ping.
3. Do not discard the packing material until
you have carefully inspected and satisfactorily
operated the tool.
4. If any parts are damaged or missing, return
the product for replacement.
E N G L I S H •
WARNING: If any parts are broken or miss-
ing, DO NOT attempt to plug in the power cord
or operate the saw until the broken or missing
parts are replaced. Failure to do so could result
in possibly serious injury.
To prevent accidental starting that could cause
serious personal injury, always disconnect the
tool from the power source when assembling
parts.

OPERATION INSTRUCTIONS

APPLICATIONS
• Sanding finish and flooring finish of wood-
work products.
• Base polishing of Lumber-coated planes.
• Sanding finishes of metal surfaces.
• Base polishing of metal-coated planes, rust
removal, or paint removal paint to refinishing.
• Superficial finish of slate, concrete, and so on.
1
BEFORE OPERATION
WARNING: This sander should never be con-
nected to power supply when assembling parts,
2
making adjustments, assembling or replacing
sandpaper, cleaning or when not in use. Discon-
necting the sander will prevent accidental start-
3
ing that could cause serious personal injury.
INSTALLING THE SANDING BELT
1. Position the sander with base facing up-
ward. Pull lever with finger, idle pulley will
then move backward.
2. Place on drive pulley and idle pulley passing
it over the outside of shoe plate and making
sure that arrow on inside of belt coincides with
rotational direction of drive pulley.
3. Push lever with finger, idle pulley will then
move forward and give proper tension to sand-
ing belt. In this case, be careful not to be hit
your finger by lever. Then, adjust sanding belt
position.
CAUTION: Sanding belt installed in the wrong
direction will lower work efficiency and shorten
life of sanding belt.
UNISTALLING SANDING BELT
To remove the sanding belt, pull the release
lever and remove the sanding belt.
U se r ' s m an ua l
11