Electric Connections - Quick TCD 1062 Manual De Instalacion Y Uso

INSTALLATION
GB

ELECTRIC CONNECTIONS

The TCD 1062 complies with EMC standards (electromagnetic compatibility) but requires correct installation to avoid
compromising its performance and that of the surronding instruments.
For this reason the TCD 1062 wires must be positioned at a distance of at least:
• 1 m away from cables that carry radio signals (except SSB radio transmitters).
• 2 m away from cables for SSB radio transmitter signals.
Follow the rules below to construct the electrical installation relative of the TCD 1062:
• Connect the TCD 1062 connectors to the connectors coming from the thrusters (use a splitter, not supplied).
• Put in a switch, to turn on and shut off the TCD 1062 (not provided).
• Position the switch so that it is within easy reach should it be necessary to shut off the remote control in an emer-
gency.
• Insert a 4A quick-acting fuse on the TCD 1062 power supply line (not provided).
• Insert a 100mA quick-acting fuse on the TSC command power supply line (not provided).
• Use wires, for the remote control power supply, with a correct cross section according to their length.
• Do not use supply from the motors or thrusters battery circuit for the TCD 1062.
• Before switching on the power to the TCD 1062, check that all the electrical connections are correct.
ELECTRICAL CONNECTIONS DIAGRAM
TCD 1062
RED
BLACK
FUSE
SPLITTER
for TCD (TCDSP)
*
TO THE SERVICES BATTERY
* Common negative for the battery groups.
14
RED
BLACK
SPLITTER
for TMS
(TMSSP)
EXTENSION
TMS
EXTENSION
MOTOR
SWITCH
FUSE
*
BATTERY
TCD 1062 - REV001A