Operating The Blender; Safety System - Electrolux ASB8000 Instrucciones De Uso

822 949 412_ASB8000.book Seite 32 Donnerstag, 29. Mai 2008 8:18 08
g
0 Insert the blade assembly into the
blender tank from the bottom. Turn
it clockwise to fasten it (Fig. 5).
Caution! Handle carefully!
You can use the filler cup as tool.
3
The blender tank will leak if the
blade assembly is not assembled
correctly.
0 Seat the tank on the motor hou-
sing.
0 Set the lid on the blender tank.
0 Insert the filler cup, and lock it in.

Operating the Blender

Place the blender on a level, dry
3
surface.
0 Plug the power cord into a power
outlet.
0 Open the lid (Fig. 1/B) and put all
the required ingredients in the
blender tank.
Important! Do not exceed the
maximum capacity of 1.6 litres.
You can add other ingredients
3
through the filler hole while the
blender is running. You can use the
filler cup in the lid to do this (Fig. 1/
A). Close the filler hole immediately
after, to avoid splashing.
Do not start the blender without
1
the lid (Fig. 1/B) in position.
Although the lid fits firmly to the
blender tank, we advise when
blending liquid ingredients, to
place your hand on the lid as you
initially start blending. As the pow-
erful motor could cause the liquid
to surge up causing leakage. Once
you have started blending you can
remove your hand.
0 Start the blender by turning the
Speed Selector (Fig. 1/G) to the
right, or by pressing the PULSE
Button (Fig. 1/H).
32
We recommend starting with
3
blender Speed 1, then progressing
to Speed 2 or 3. The PULSE But-
ton runs the blender at full speed.
The „Blending guide" on page 34
shows the functions that can be
performed and the suggested
speeds to use.
0 After you have completed blen-
ding, turn the Speed Selector off to
position .
0 After mixing, first remove the blen-
der tank, before taking off the lid.
Do not let the blender run for more
1
than 2 minutes at a time using
heavy loads. After running for 2
minutes with heavy loads, the
blender should be left to cool for at
least 10 minutes.

Safety System

The safety system prevents the
blender from being operated if the
blender tank is not correctly
seated.
You should nevertheless still keep
1
children away from the appiance.
Ice crushing
The blender can be used for crush-
ing ice.
0 Simply add ice to the blender then
press the PULSE button and hold
for 1-2 seconds and release.
Continue this process and in sec-
onds your ice is crushed.
Processing hot liquids
If you would like to process hot liq-
uids please allow to cool down
until lukewarm, fill the blender tank
only half full and start processing
on low speed.