Publicidad
Enlaces rápidos
SUPPLIED MATERIAL
Allen key / Llave allen / Inbusschlüssel
1
Bracket / Pletina / Montageplatte
2
Lamp structure / Estructura luminaria / Leuchten-Struktur
3
TECHNICAL SPECIFICATIONS
Empty
Design by Xuclà
ASSEMBLY INSTRUCTIONS
INSTRUCCIONES DE MONTAJE
MONTAGEANLEITUNG
MATERIAL SUMINISTRADO
1.
ESPECIFICACIONES TÉCNICAS
GELIEFERTES MATERIAL
2.
4125.
4125
4130
1 un.
1 un.
1 un.
1 un.
1 un.
1 un.
3.
4130.
TECHNISCHE DATEN
Publicidad
Manuales relacionados para VIBIA Empty 4125
Resumen de contenidos para VIBIA Empty 4125
- Página 1 Empty Design by Xuclà ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE MONTAJE MONTAGEANLEITUNG SUPPLIED MATERIAL MATERIAL SUMINISTRADO GELIEFERTES MATERIAL 4125. 4130. 4125 4130 Allen key / Llave allen / Inbusschlüssel 1 un. 1 un. Bracket / Pletina / Montageplatte 1 un. 1 un. Lamp structure / Estructura luminaria / Leuchten-Struktur 1 un.
-
Página 2: Important Notice
ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE MONTAJE MONTAGEANLEITUNG IMPORTANT NOTICE: Switch of the mains before installing the lamp. 1. Open the packaging. 2. Remove the cardboard panels from the top and side as shown in the drawing. IMPORTANT: Inside of superior cardboard contain the fixing bracket (A) and assembly instructions, read them completely before continuing. - Página 3 ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE MONTAJE MONTAGEANLEITUNG 4. Fix the bracket (A) to the floor using the most suitable screws and plugs. Important: the head of the screw must not project outside the width of the bracket. 5. Open out the box fully, keeping the white protective sheet and the cardboard at the bottom for support.
- Página 4 ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE MONTAJE MONTAGEANLEITUNG 7. Run the electrical cable through the hole in the casing (B) until it comes out of the top hole. 8. Lie the casing (B) down so that it is snugly lined up with the bracket (A). NOTE: To avoid damage to the side at the bottom, before lying the casing down make sure it is properly lined up with the bracket.
- Página 5 ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE MONTAJE MONTAGEANLEITUNG L=22 cm. 10. Before making the electrical connection at the connection cylinder, to make it easier to open and close the cover later on you are advised to leave 22cm. Remove the protective plastic bag. 11.
- Página 6 ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE MONTAJE MONTAGEANLEITUNG 12. Close the cover (D) and secure it with the two screws (C), using the allen key supplied. 12. Ccerrar la tapa (D) asegurándola con los dos tornillos (C), usar la llave allen suministrada. 12.