Renfert Vortex compact 2 L Instrucciones De Servicio página 4

During operation
Take care not to damage
the mains lead (e.g. by
driving over, pinching or
dragging). Pull out the
mains plug only directly at
the plug, i.e. not by pulling
at the mains lead.
Before picking up liquids,
the filter bag must be re-
moved and the function of
the float switch checked.
If foaming is observed,
stop work immediately
and empty the tank.
Connect to a properly
grounded outlet only.
Maintenance and repair
CAUTION!
Before cleaning and ser-
vicing the cleaner, always
remove the mains plug.
Carry out only mainte-
nance operations des-
cribed in these operating
instructions.
Use only original spare
parts.
Do not make any technical
modifications to the clea-
ner.
CAUTION!
Your safety could be en-
dangered as a result!
For all other maintenance
and repair work, please
contact Denerica or an
authorised specialist work-
shop!
Electrical equipment
2
Check the rated voltage of
the cleaner before connec-
ting it to the mains power
supply. Ensure that the
voltage specified on the
rating plate corresponds to
the local mains voltage.
When using an extensi-
on lead or replacing the
mains lead, the lead type
speci-fied by the manuf-
acturer must always be
used.
We recommend that the
power supply to the clea-
ner be connected to a
grounded, GFCI-protected
socket.
When using an extension
lead, observe the mini-
mum cross-sections of the
leads:
Cable length Cross-
feet section
up to 60 14 AWG
60 to 150 12 AWG
Always arrange the cur-
rent-carrying parts (plug
sockets, plugs and con-
nectors) and lay extension
leads so that the protec-
tion class of the cleaner is
maintained.
CAUTION!
Never spray the top sec-
tion of the cleaner with
water: Danger for persons,
danger of short circuits.
The latest edition of the
IEC Regulations and the