Intended Use; Assembly And Adjustments - DeWalt DWE315 Manual De Instrucciones

COMPONENTS (Fig. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Variable speed trigger
B. LED worklight
C. Accessory clamp lever
D. Lock-on button

INTENDED USE

This oscillating multi-tool is designed for professional detail sanding,
plunge cutting, flush cutting, removal of excess materials and surface
preparation applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
This oscillating multi-tool is a professional power tool. DO NOT let
children come into contact with the tool. Supervision is required when
inexperienced operators use this tool.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
WARNING: Risk of lacerations or burns. Do not touch the
sharp edges of accessories at any time. Do not touch workpiece
or blade immediately after operating the tool. They can become very
hot. Handle carefully. Always allow accessories and workpiece to
cool before handling.
E. Accessory side mount
F. Cut guide block
G. Cut guide arm
Installing/Removing Accessories
(Fig. 2–4)
TOOL-FREE ACCESSORY CLAMP
The DWE315 features a quick change
accessory system. This allows for faster
accessory changes without the need for
wrenches or hex keys like other oscillating
tool systems.
1. Grasp the tool and squeeze the
accessory clamping lever (C) as
shown in Figure 2.
2. Clean any residual debris from the tool
shaft and the accessory holder.
3. Slide the accessory between the shaft (H) and the accessory
holder making sure the accessory engages all eight pins on the
holder and is flush with the shaft.
4. Release the accessory clamp lever.
NOTE: Some accessories, such as scrapers and blades, can be
mounted at an angle if required as shown in Figure 4.
FIG. 3
5
FIG. 2
C
FIG. 4
H