Other Information - OK. OLE 396 B-D4 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
Chapter 6
time you have set comes. When time is
out and you do not execute any operation,
scheduled recording will start automatically.
- Repeat type: set different repeat modes for
the recording.
4. Press ▲/▼/◄/ ► to select Add, then press OK
to add the schedule you set into your schedule
list.
5. Press the red button to repeat above
procedures to add another schedule.
6. If you wish to edit or delete a schedule, select
it and press OK to enter.
7. Press Exit to close the menu.

Other information

Password in Parental Control
- The default password is 1234. You can change it
to a new one.
- The super password is 0423. If you forget your
code, enter the super password to override any
existing codes.
Troubleshooting
Please check the following list before requesting
service.
There is no picture or sound.
Make sure the power cord is properly inserted in
the power outlet.
Make sure the source type is set correctly.
Make sure the antenna is properly connected.
Make sure the volume is not set to minimum or
the sound is not set to mute.
Make sure the headphones are not connected.
Reception other than those of broadcasting
stations can be considered.
Picture is not clear.
Make sure the antenna cable is properly connected.
Consider whether your TV signal is being
properly received.
Poor picture quality can occur due to a VHS
camera, camcorder, or other peripheral being
connected at the same time. Switch off one of
the other peripherals.
The 'ghost' or double image may be caused
by obstruction to the antenna due to high-
rise buildings or hills. Using a highly directional
antenna may improve the picture quality.
The horizontal dotted lines shown on
the pictures may be caused by electrical
interference, e.g., hair dryer, nearby neon lights,
etc. Turn off or remove these.
Picture is too dark, too light or tinted.
Check the colour adjustment.
Check the brightness setting.
Check the sharpness function.
The fluorescent lamp may have reached the end
of its service life.
Remote control does not work.
Check the batteries of the remote control.
Make sure the remote sensor window is not
under strong fluorescent lighting.
Try to clean the remote control sensor lens on
the TV with a soft cloth.
If the above suggestions do not solve your
technical issue, please refer to the warranty card
for service information.
Television specifications
TV Broadcasting
Receiving channels
Tuner type
OSS Notice
This product uses some software programs which
are distributed under the Freetype Project.
This product uses some software programs which
are distributed under the zlib license.
This product uses UNICODE software programs
which are distributed under IBM Open source
license.
This product uses glibc software programs which
are distributed under the GNU license.
Design and specifications are subject to change without notice.
EN 15
Other information
PAL/SECAM BG/DK/I/LL'
VHF/UHF/Cable
Frequency synthesized

Publicidad

Tabla de contenido
loading

Tabla de contenido