Mounting Of Protector - Dolmar MS-4215 Instrucciones De Manejo

For model MS-4215
– After assembling the handle, fit the control cable to the shaft by two clips (1).

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector
combinations as indicated in the table must be used.
Be sure to use genuine DOLMAR cutter blades or
nylon cutting head.
– The cutter blade must be well polished, free of cracks or breakage. If
the cutter blade hits against a stone during operation, stop the engine
and check the blade immediately.
– Resharpening or replace the cutter blade every three hours of
operation.
– If the nylon cutting head hits against a stone during operation, stop the
engine and check the nylon cutting head immediately.
CAUTION: The appropriate protector must always be installed, for your
own safety and in order to comply with accident-prevention
regulations.
Operation of the equipment without the guard being in place
is not permitted.
The outside diameter of the cutter blade must be 255 mm
(10"). Cutter blades with outside diameter of 305 mm or
12 inches can be used only for those with two or three
blades.
Metal blade
Nylon cutting head
10
Clips (1)
Protector for metal blades
Protector for nylon cutting head