Liftmaster ® Internet Gateway (Not Provided); To Erase All Codes From The Door Control (Myq Control Panel) Memory; Additional Light - LiftMaster 8500 Manual Del Usuario

Programming
®
LiftMaster Internet Gateway (Not Provided)
®
The LiftMaster Internet Gateway gives you control of your garage door from your internet
connected computer or mobile device. You must have your LiftMaster
registered to your customer account at myLiftMaster.com in order to use it with the MyQ
Control Panel. Go to myLiftMaster.com and follow the instructions to create an account
and register your device if you have not already.
®
To program your MyQ Control Panel to the LiftMaster
1. Go to myLiftMaster.com from a computer or mobile device.
2. Click on "Manage Places>Add New Device>Garage Door Opener" and follow the
directions.
3. Once you click ADD you have 3 minutes to press the LEARN button two times on the
®
MyQ control panel. The red learn LED will turn on.
4. The red learn LED will turn off when programming is complete. Once the control
panel is learned, it will appear on your screen. You can then name the device (e.g.,
My Control Panel, etc.).
IMPORTANT NOTE: Model 580LM Alternate Power Supply may be installed if an outlet
is not located near the garage door opener. MyQ
however all other MyQ ® devices (LiftMaster
if using the Model 580LM Alternate Power Supply. If you would like to use these features,
contact an electrician to install an outlet near the garage door opener.
To Erase All Codes From the Door Control (MyQ
Control Panel) Memory
Erase all remote controls and keyless entries:
1. Press and hold the LEARN button on the control panel until the red learn LED goes
out (approximately 6 seconds). All remote control and keyless entry codes are now
erased. Reprogram any compatible accessory you wish to use.
Erase all devices (including MyQ
1. Press and hold the LEARN button on the control panel until the red learn LED goes
out (approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the red learn LED goes
out. All codes are now erased. Reprogram any compatible accessory you wish to
use.
Reprogramming Remote Light or Additional Light
Your garage door opener remote light has already been programmed at the factory to
operate with your opener. Any additional or replacement remote lights will need to be
programmed.
1. Press the LEARN button on the light until the LED comes ON.
2. Activate the garage door opener using the hand-held remote, door control, or
keyless entry.
3. The code has been programmed when the remote light comes on.
®
Internet Gateway:
®
light controls will continue to work
® Internet Gateway) and TTC WILL NOT work
® enabled accessories):
®
Internet Gateway
®
®
27
Model 828LM
LiftMaster ® Internet
Gateway
Red Learn LED