Erase All Codes; Liftmaster Internet Gateway; Erase A Liftmaster ® Internet Gateway - LiftMaster SL 600 Manual De Instalación, Operación Y Manutención

PROGRAMMING

Erase All Codes

1. Press and hold the
2. Hold the LEARN button for approximately 8 seconds. LED1 will go out and all remote control codes
are now erased.
®
LiftMaster Internet Gateway
IMPORTANT: The MyQ feature, Internet Gateway and its accessories are not permitted for use in the
countries of Peru and Chile.
To program the operator to the LiftMaster
1. Connect the Ethernet cable to the LiftMaster
2. Connect power to the LiftMaster
3. Create an online account by visiting www.myliftmaster.com.
4. Register the LiftMaster
5. Use an internet enabled computer or smartphone to add devices. The LiftMaster
will stay in learn mode for three minutes.
6. Press the LEARN button on the operator (LED1 will light as it enters learn mode). The LiftMaster
Internet Gateway will pair to the operator if it is within range and LED1 will fl ash and go out if
programming is successful.
Erase a LiftMaster
1. Press and hold the
2. Hold the LEARN button for approximately 8 seconds. LED1 will go out and all remote control codes
are now erased.
3. Press and hold the LEARN button a second time, LED1 will light again.
4. Hold the LEARN button for approximately 8 seconds. LED1 will go out and all gateways are now
erased.
LEARN
button, LED2 will light.
®
Internet Gateway:
® Internet Gateway.
®
Internet Gateway.
®
Internet Gateway
LEARN button, LED1 will light.
®
Internet Gateway and the router.
19
®
Internet Gateway
®