Troubleshooting - Gardol GAM-E36Li Manual De Instrucciones

11. Troubleshooting

Fault
The motor fails to
start
The motor perfor-
mance drops
Cutting is irregular
Notice! For protection, the motor is equipped with a thermal switch which cuts out when the
motor is overloaded and switches on again automatically after a short cooling period
Anl_GAM_E_36_Li_SPK7.indb 28 Anl_GAM_E_36_Li_SPK7.indb 28
GB
Possible causes
a) The capacitor is defective
b) The connectors have become
separated from the motor or the
capacitor
c) The mower is standing in high
grass
d) The mower housing is clogged
e) Safety switch is not inserted
f) Battery is not correctly inserted
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
d) Battery performance decrea-
sing
a) The blade is worn
b) Wrong cutting height
- 28 -
Remedies
a) The mower housing is clogged.
Have repaired by the Customer
Service Center
b) Have repaired by the Customer
Service Center
c) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary
d) Clean the housing so that the blade
moves freely
e) Insert safety switch (see 6.)
f) Remove the battery and reinsert
(see 5.)
a) Correct the cutting height, change
the electronics setting
b) Clean the housing
c) Replace the blade
d) Check the battery performance
and charge the battery if necessary
(see 5.)
a) Replace or resharpen the blade
b) Correct the cutting height
04.11.14 16:17 04.11.14 16:17