Connecting Your P3 Headphones - Bowers & Wilkins P3 Manual De Instrucciones

3. Connecting your P3 Headphones

Your P3 Headphones can be connected to any
audio device with a 3.5mm jack headphone output.
The Made for iPod cable fitted to P3 Headphones
incorporates an iPhone, iPod and iPad compatible
microphone and audio control. Its use is described
in the following section of this manual.
If using your P3 Headphones with anything other
than an Apple device the Made for iPod cable may
occasionally result in unreliable connection. For
such a case the supplied universal cable can be
substituted. Detaching the Made for iPod cable and
fitting the universal cable is described below and
illustrated in diagram 4.
• Unfold the headphones and remove each earpad
by gently pulling it away from the body of the
earpiece. Removing the earpads reveals the cable
connection plugs and sockets.
• Working on one earpiece at a time, gently
grasp the connection plug and pull it from the
connection socket. Pull on the plug rather than
the cable itself. Lift the cable out of its routing
channel.
• With the Made for iPod cable now disconnected,
take the universal cable and identify the left and
right connection plugs. L or R identification is
moulded into each plug.
• Insert the left connection plug into the left
earpiece socket and press the cable into its
routing channel. Repeat for the right earpiece.
• Replace the earpads. Make sure that the earpad
location pins and sockets engage accurately.
4. Using your P3 Headphones with
iPod, iPhone or iPad
Your P3 Headphones incorporate a combined
microphone and audio control, integrated within
the Made for iPod cable, that enables you to make
or answer calls while wearing the headphones.The
control also enables you to play, pause and skip
songs. The microphone and control is illustrated in
diagram 5.
The control incorporates three click switches, one in
the middle and one at either end, and operates as
follows:
• Click the end switch engraved "+" to increase
phone or song volume.
• Click the end switch engraved "–" to decrease
phone or song volume.
• Click the middle switch once to answer a call.
• Click the middle switch once to end a call.
• Click the middle switch once to play or pause
a song.
• Click the middle switch twice to skip to the
next song.
• Click the middle switch three times to skip to the
previous song.
Diagram 4
Changing the cable
1x
1x
2x
3x
Diagram 5
The microphone and audio controls
L
4