Fein RS10-70E Manual De Instrucciones página 13

OBJ_BUCH-0000000019-003.book Page 13 Friday, November 13, 2015 10:44 AM
en Original Instructions for Pipe Sander.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this work step, pull the mains plug out of the socket. Otherwise there will
be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Additional information.
Gripping surface
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environmental-friendly recycling.
Product with double or reinforced insulation
Low sanding-belt speed
High sanding-belt speed
Character Unit of measure-
ment, international
P W
1
P
W
2
v
m/s
0
U
V
f
Hz
M...
mm
Ø mm
l
mm
1
l
mm
2
mm
kg
L dB
pA
L
dB
wA
L
dB
pCpeak
K...
2
m/s
2
m/s
h
Unit of measure- Explanation
ment, national
W Power input
W Output
m/s Sanding-belt speed
V Rated voltage
Hz Frequency
mm Size of metric thread
mm Diameter of a round part
mm Sanding-belt length
mm Sanding-belt width
mm Maximum pipe diameter
kg Weight according to EPTA-Procedure 01
dB Sound pressure level
dB Sound power level
dB Peak sound pressure level
Uncertainty
2
m/s Vibrational emission value according to EN 60745
(vector sum of three directions)
2
m/s Vibrational emission value (sanding)
en
13