Explanation Of General View; General Power Tool Safety Warnings - Makita MLT100 Manual De Instrucciones

ENGLISH (Original Instructions)
1. Hole diameter 8 mm
2. 6 mm std. washer
3. No. 10 wood screw 40 mm min.
length
4. 6 mm Mounting bolt & Nut tighten
securely
5. Push stick
6. Rip fence (Guide rule)
7. Miter gauge
8. Handle
9. Arrow pointer
10. Lock lever
11. 90° adjusting screw
12. 45° adjusting screw
13. Switch
14. Restart button
15. Screws
16. Sub table (R)
SPECIFICATIONS
Model
Arbor hole
Blade diameter
90°
Max. cutting
capacities
45°
No load speed (min
Table size (L x W)
Dimensions (L x W x H) with
table (s) not extended
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. DOUBLE INSULATION
............. Wear safety glasses.
............. Do not place hand or fingers close to the
blade.
8

Explanation of general view

17. Sub table (back)
18. Slide table
19. Locking plate
20. Wrench
21. Hex nut
22. Inner flange
23. Ring
24. Saw blade
25. Outer flange
26. Blade guard
27. Riving knife
28. Blade guard mounting portion
(stay)
29. Blade
30. These two clearances should be
equal.
31. Hex bolts (A)
32. Hex bolts
(for European countries)
-1
)
(685 mm - 835 mm) x (955 mm - 1,305 mm)
with sub tables (R) and (back)
726 mm x 984 mm x 333 mm with sub
tables (R) and (back)
MLT100
30 mm
260 mm
93 mm
64 mm
34.1 kg
Intended use
END215-3
The tool is intended for cutting in wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
33. Lever
34. Scale
35. Guideline
36. Screw
37. Face/edge parallel
38. Wood screw
39. Glue together
40. Auxiliary fence
41. Push block
42. Cross cutting
43. Mitering
44. Bevel cutting
45. Compound mitering (angles)
46. Knob
47. Brush holder cap
48. Screwdriver
(for other than European countries)
25 mm and 25.4 mm
255 mm
90.5 mm
63 mm
4,300
(685 mm - 835 mm) x (955 mm - 1,305 mm)
with sub tables (R) and (back)
726 mm x 984 mm x 333 mm with sub
tables (R) and (back)
34.1 kg
/II
ENE003-1
ENF002-1
GEA010-1