Explanation Of General View; Wall Chaser Safety Warnings - Makita SG1250 Manual De Instrucciones

ENGLISH
(Original instructions)
1 Shaft lock
2 Notch
3 Scale
4 Clamping screw
5 Slide switch
6 Hex socket head bolt
7 Blade case
8 Base
SPECIFICATION
Rated speed (n) / No load speed (n
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting tracks in concrete walls or
cutting in ferrous materials or concrete drainage chan-
nels with a diamond wheel but without using water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.

Explanation of general view

9 Shaft lock button
10 Lock nut
11 Lock nut wrench
12 Diamond wheel
13 Space ring 6 (6 mm thick)
14 Space ring 3 (3 mm thick)
15 Front handle
16 Cam
Model
Wheel diameter
Max. wheel thickness
)
0
Spindle thread
Overall length
Net weight
Safety class
ENE026-1
ENF002-2
GEA010-1
17 Dust nozzle
18 Vacuum cleaner
19 Hose
20 Hex wrench
21 Inhalation vent
22 Exhaust vent
European countries
Other countries

WALL CHASER SAFETY WARNINGS

1. The guard provided with the tool must be
securely attached to the power tool and posi-
tioned for maximum safety, so the least amount
of wheel is exposed towards the operator. Posi-
tion yourself and bystanders away from the
plane of the rotating wheel. The guard helps to
protect operator from broken wheel fragments and
accidental contact with wheel.
2. Use only diamond cut-off wheels for your power
tool. Just because an accessory can be attached to
your power tool, it does not assure safe operation.
3. The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool. Accessories running faster than
their rated speed can break and fly apart.
4. Wheels must be used only for recommended
applications. For example: do not grind with the
side of cut-off wheel. Abrasive cut-off wheels are
intended for peripheral grinding, side forces applied
to these wheels may cause them to shatter.
5. Always use undamaged wheel flanges that are of
correct diameter for your selected wheel. Proper
wheel flanges support the wheel thus reducing the
possibility of wheel breakage.
6. Do not use worn down reinforced wheels from
larger power tools. Wheels intended for a larger
power tool are not suitable for the higher speed of a
smaller tool and may burst.
7. The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories can-
not be adequately guarded or controlled.
SG1250
125 mm
2.1 mm
–1
10,000 (min )
–1
9,000 (min )
M14
346 mm
4.4 kg
/II
GEB112-4
5