Function Description - Pontec PondoMatic Instrucciones De Uso

- EN -
Product Description
Delivery scope and unit configuration
The parts included in the scope of delivery are inside the container and have to be removed first!
How to proceed:
 A
1. Undo the side locking clips and remove the motor housing.
2. Take all loose parts out of the container.
3. Replace the motor housing and close the locking clips.
 A PondoMatic
1 Motor housing
2 ON/OFF switch
3 Container
4 Locking clip
5 Inlet, suction hose connection
6 Outlet, drain hose connection
7 Suction hose
8 Drain hose
9 Extension tube
10 Adjustable universal nozzle
− Nozzle fully open (10 mm): Suitable for pond liner, no pebbles at the bottom of the pond, thick layer of sludge
− Nozzle closed (2 mm): Suitable for pond liner, layer of pebbles at the bottom of the pond, thick layer of sludge
11 Algae nozzle
12 Crevice nozzle

Function description

PondoMatic is a special pond vacuum for removing sludge from ponds and pools.
• High performance vacuum with 1400 watt motor.
• Switches over automatically between suction and emptying mode.
• The delivery scope includes:
– Crevice nozzle, algae nozzle and universal nozzle (adjustable from 2 to 10 mm).
– 4 m suction hose and 2 m drain hose
Operation
Set-up the unit
 B
• Place the unit at least 2 m from the pond and above the water level.
• Place the unit on level ground so that it is securely positioned and cannot tip over.
Establishing the connections
How to proceed:
 C
1. Attach the drain hose to the outlet fitting on the container.
– Route the drain hose with an incline to ensure that the extracted water can drain via gravity.
2. Attach the suction hose to the inlet fitting on the container.
3. Fit the extension tubes to the suction hose.
4. Fit the desired nozzle to the end of the extension tube.
– Adjust the universal nozzle to the pond floor conditions. ( Delivery scope and unit configuration)
12
Quantity
1
1
1
2
1
1
1
1
4
1
1
1