Epson TM-P60 Manual Del Usuario página 17

CAUTION:
Do not wipe the roll paper end sensor with water or alcohol. Its functional
capabilities may be affected.
4. Close the roll paper cover after the water or alcohol has dried.
Cleaning the Peeler Unit
After the peeler is used for a prolonged period of time, the glue from the labels
accumulates on the rollers of the peeler unit. If you leave the rollers in such a
condition, the glue may stick to issued labels, or a paper jam may occur. To
prevent malfunctions and maintain good print quality, clean the rollers regularly
(every 20,000 labels).
You can clean them easily if you use a wasted label, as shown in illustration
Note:
Do not use any alcohol based solvents for cleaning. Such solvents may enter the roller shaft
and cause a malfunction of the peeler.
Using Different Paper Widths
6 paper widths from 29.5 mm to 57.5 mm are available by using the roll paper
guide. If you remove the roll paper guide, you can also select 59.5 mm.
1. Press the button and open the peeler holder and the roll paper cover.
2. Remove the roll paper if there is one.
3. Insert your finger into the hole of the roll paper guide and lift it upward.
Undo the top part that is fixed in one of the slots. See illustration
4. Move the roll paper guide to the position matching the width of the paper
you are using.
5. Insert the top of the roll paper guide and press it down until it clicks.
6. Insert the roll paper. See "Installing Roll Paper" for detailed information.
Note:
Do not increase the paper width after you have used a narrower width because if the
printer has ever been used with narrow paper, part of the head contacts the platen.
Therefore, when a wider setting is used, part of the head may be worn out, which can cause
poor printing.
How to Set Up the Network
Preparation
Printing a Status Sheet
Make sure the printer is turned off and the roll paper cover is closed properly.
Power on the printer and then open the roll paper cover. Hold down the FEED
button until the printer beeps (about 2 seconds). Close the roll paper cover. The
printer prints the parameters for the printer. You can check all setting values
necessary (SSID, Network mode, IP address, Subnet mask, Gateway address) for
the network connection.
TM-P60 with Peeler User's Manual 11
English
O
.
P
.