Optional Accessories - Makita DWT310 Manual De Instrucciones

NOTICE:
Washer and nut have head and tail. Head
has identification mark for nut and chamfer for washer.
When placing them, be careful not to place in reverse.
► Fig.17: 1. Identification mark 2. Nut 3. Bolt
4. Chamfered 5. Washer
NOTICE:
Replace nut, bolt and washer all
together at one time when these rotate together,
nut rotates excessively or a bolt protrude from
nut surface too much or less.
NOTICE:
Do not reuse used nut, bolt and washer.
The range for the remaining length of bolts after cutting
off the bolt tips are determined by bolt size. Refer to the
table below and choose shear bolts according to the
thickness of workpiece to be fastened.
Bolt size Maximum remain-
ing length
M16 20 mm
M20 15 mm
M22 14 mm
► Fig.18: 1. Remaining length
NOTICE:
Use bolts with the remaining length within the
range shown in the table above as bolts with different size
have different maximum and minimum remaining length.
NOTICE:
Be careful not to use bolts beyond the
specified range which may cause the tool malfunction.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Battery guard
WARNING:
Do not remove the battery guard.
Do not use the tool with the battery guard removed
or damaged. Direct impact to the battery cartridge
may cause battery malfunction and result in injury and/
or fire. If the battery guard is deformed or damaged,
contact your authorized service center for repairs.
CAUTION:
Do not attach a strap to the battery
guard for hanging the tool.
CAUTION:
Do not attach the shoulder belt to
the battery guard.
► Fig.19: 1. Battery guard 2. Battery guard holder
OPTIONAL
ACCESSORIES
are recommended for use with your Makita tool
specified in this manual. The use of any other
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
Minimum remain-
ing length
4.5 mm
5.5 mm
7 mm
•
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
9 ENGLISH
CAUTION:
These accessories or attachments
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
Bolt size
M16 Outer sleeve
Inner sleeve
M20 Outer sleeve
Inner sleeve
M22 Outer sleeve
Inner sleeve
M22 Outer sleeve
Inner sleeve
5/8" Outer sleeve
Inner sleeve
3/4" Outer sleeve
Inner sleeve
3/4" Outer sleeve
Inner sleeve
Makita genuine battery and charger
Sleeve Length
35 mm
36 mm
37 mm
38 mm
39 mm
39 mm
85 mm
85 mm
35 mm
36 mm
37 mm
38 mm
83 mm
84 mm