Yamaha NX-N500 Manual De Instrucciones página 78

Ocultar thumbs Ver también para NX-N500:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Table of status indicator conditions
Indications during playback
Color
Lit
Flashing
Green
Slow flashing
Fading every 3
seconds
Lit
Pink
Slow flashing
Lit
Blue
Slow flashing
Lit
Sky blue
Slow flashing
Lit
Purple
Slow flashing
Lit
White
Flashing
All colors
listed above
Fading every 2
seconds
Indications concerning the system
Color
Lit
Orange
Lit
Yellow
Flashing
Slow flashing
White
Fading every 3
seconds
Indications when the error occurred
Color
Slow flashing
Orange
Flashes twice
Slow flashing
Red
Repeatedly
flashes twice
Repeated
flashes three
times
Condition
1 second
1 second
3 second
3 second
1 second
1 second
1 second
1 second
1 second
1 second
1 second
1 second
(example)
(example)
2 second
2 second
Condition
1 second
1 second
3 second
3 second
Condition
1 second
1 second
1 second
1 second
1 second
1 second
Status
The network input is selected.
A network connection is being set up.
No connection is established with the network.
Audio is being received from the MusicCast CONTROLLER.
The unit is connected to an iOS device (AirPlay).
The iOS device settings are being shared and a connection
has been established wirelessly (Wireless Accessory
Configuration).
The Bluetooth input is selected.
Bluetooth cannot be paired.
The USB input is selected.
No PC is connected to the USB jack.
The optical digital input is selected.
No device is connected to the OPTICAL jack.
The AUX input is selected.
The volume setting is changed.
Speaker output is muted.
Status
The unit is in standby mode.
The unit is in network standby mode.
A new firmware update is available.
The firmware is being updated.
The firmware has been successfully updated.
Status
Check the connections of the right speaker.
No presets have been registered.
The AC power supply cable is not firmly connected to the
AC wall outlet. Connect the AC power supply cable firmly to
the AC wall outlet.
The protection circuitry has been activated. Turn off the
unit, disconnect the AC power supply cable, and contact
the nearest authorized Yamaha dealer or service center.
The firmware download cannot be found. Check that this
unit is connected to the network.
An error occurred during firmware updating. To restart
updating, press WIRELESS DIRECT on the rear panel.
English
See page
p.18, 20, 21
p.12
p.12
p.18, 20, 21
p.23
p.15
p.24
p.26
p.27
p.27
See page
p.11
p.28
See page
p.9
p.22
p.10
p.33
p.28

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido