Operation; Before Commisioning; Retraction Prior Initial; Operating - Holzmann ED 400FD Manual De Instrucciones

OPERATION

OPERATION

17.1 Before commisioning

 Lubricate all a bare machine parts with an acid-free lubricating oil.
 Function of the movable and fixed parts of control
 Lubricate the lathe from according to lubrication chart.
 Check all screws for ease of movement.
 Check that the fixing screws of the chuck are tight.
 Clamp a workpiece in the lathe chuck, lathe or turning the clamping jaws of the chuck
completely together before turning on the lathe.

17.2 Retraction prior initial

The retraction should be performed with the lowest screw speed. Let the machine at this speed
run for about 20 min. Check out irregularities, such as unusual noises, imbalances, etc. If every-
thing is in order, gradually increase the speed.

17.3 Operating

W A R N I N G
Each time before starting the spindle speed controller must be set
to the lowest level!
Chuck cover must be in lowest position!

17.4 Motor starting / stopping

To start, press the green button ˝I˝
To stop, press the red button ˝O˝

17.4.1 Setting the spindle speed

The spindle speed can be set with the spindle speed controller (16).
The adjusted spindle speed is displayed on the display spindle speed (20).

17.4.2 Setting the direction of spindle rotation

Turn on the switch spindle direction (1) in position ˝L˝ for spindle mode
counterclockwise, and in the position ˝R˝ for spindle mode clockwise.
In the position ˝ O ˝ is switched to idle
A T T E N T I O N
Wait at each change of direction necessarily, the machine stops, otherwise
the machine may be damaged!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 38
ED400FD