Lathe Chuck / Faceplate Assembly; Top Slide - Holzmann ED 400FD Manual De Instrucciones

17.4.12 Lathe chuck / faceplate assembly

If you mount the rotary chuck or chucks want to
dismantle or, first make sure that the holding cams are
fixed.
 Loosen the three screws (A) and lift off the lathe
chuck.
 Now mount chuck or faceplate on the spindle head
and tighten the bolts in sequence to.
 Do not replace food or face plates between different
lathes, without checking the correct adjustment
cams.
17.4.13

Top slide

For angular adjustment of the upper slide, loosen the screws, turn
the carriage to the desired position and fix the carriage again with
the screws.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
42
ED400FD