Service; Trouble Shooter; Environmental Concideration - THERMEx SLIM S4 PLUS Instrucciones De Uso

B 520423368217062016

SERVICE

Before reporting service on your Thermex range hood, it is important that you read the installation and/or user instructions carefully. It ensures that
Thermex can provide you the best possible assistance.
Service department at Thermex can be contacted in preparation to:
• Technical support for installation and installation of your range hood.
• Clarification of functionalities in your hood.
• Service Request during the warranty on your hood ..
Before a service request during the warranty always try to disconnect the power to the hood for about 5 min. Then plug the power back on to see if the
problem is corrected.
If the problem is not corrected, disconnect the power supply to the hood for one hour. If the hood is still not functioning properly after the power has
been off for an hour, and in the troubleshooting charts are reviewed, contact the service department.
NOTE: For inquiries within the warranty, you will be asked for proof of your purchase in the form of a sales receipt. Therefore, always store your purchase
receipt
Before the request for service requests within the warranty, it is important to have all the necessary information ready:
• Error Description
• Model
• The type and serial number of the hood (on the chassis plate)
• Information on the puchase

TROUBLE SHOOTER

PROBLEM
The hood is not working
The extraction of the range hood is
not sufficient
ENVIRONMENTAL CONSIDERATIONS
PACKAGING
The packaging must be disposed of in accordance with local regulations on waste management..
SCRAPPING OF THE HOOD
The symbol on the product or accompanying documentation indicates that this product may not be disposed of as household waste but must be
delivered to the nearest collection center for the recycling of electrical and electronic equipment.
POSSIBLE CAUSE
There is no power
The hood is not connected to the power supply
The pressure valve is blocked
The duct is jammed or blocked
The filters are dirty and clogged.
THERMEX SLIM S4 PLUS
SOLUTION
Check the power supply to the hood. Disconnect
the power for approximately 5 minutes and connect
again to check if the fault is still there.
Check that the hood is connected to the power sup-
ply. Unplug for approximately 5 min, and connect it
again to check if the fault is still there.
Check if objects have fallen down on top of the valve
or whether the clamp around the valve is tightened
so hard that the valve cannot open. Loosen the
clamp or remove the object, if the valve is blocked.
Check the duct, and repair if necessary.
Check if the filters are clean, and clean if necessary.
See the section cleaning and maintenance in this
manual.
39