Velleman CCTVPROM10 Manual Del Usuario página 15

7.3.5.2 INFO
View system information, including the firmware version, MAC address, and serial number of the
system.
7.3.5.3 MD (MOTION DETECT)
Configure motion detection for each channel.
To configure motion detection:
• Under STATUS, select ON to enable motion detection for the desired channel. Click NEXT PAGE
for additional channels (8-channel models only).
• Under SENSITIVITY, select 1, 2, 3, or 4. The higher the number, the more sensitive the motion
detection.
• Under MD SETUP, click SETUP. The red motion grid appears over the selected channel in full
screen.
• Click the blocks in the grid to enable/disable motion detection. Red=motion detection enabled;
Clear=motion detection disabled.
• Right-click anywhere on the screen to return to the Motion Detection menu.
• Click APPLY. Click SURE in the confirmation window.
• Click EXIT in all menus until all windows are closed.
NOTE: You can disable the MD buzzer in the alarm setup menu.
7.3.5.4 MOBILE
Send alerts to your cellular phone Windows Mobile enabled touch-screen smart phone (Windows
Mobile 6.0 or greater, S60 3
12/04/2011
CCTVPROM10
rd
generation or greater is required).
15
©Velleman nv