Extension Cords; Functional Description; Carton Contents - Delta DP350 Manual De Instrucciones

EXTENSION CORDS

Use proper extension cords. Make
sure your extension cord is in good condition and is a
3-wire extension cord which has a 3-prong grounding
type plug and matching receptacle which will accept
the machine's plug. When using an extension cord,
be sure to use one heavy enough to carry the current
of the machine. An undersized cord will cause a
drop in line voltage, resulting in loss of power and
overheating. Fig. D-1 shows the correct gauge to use
depending on the cord length. If in doubt, use the
next heavier gauge. The smaller the gauge number,
the heavier the cord.
FOREWORD
The Delta ShopMaster Model DP350 (with a flexible work lamp) is a 12" variable speed bench drill press that allows
you to quickly and easily change drill speeds without removing the cover and/or adjusting belts.
NOTICE: The photo on the manual cover illustrates the current production model. All other illustrations contained in the
manual are representative only and may not depict the actual labeling or accessories included. These are intended to
illustrate technique only.
3
1. Drill Press Head and Motor
2. Column, Base Flange, and Rack
3. Table
4. Base
5. Chuck
6. Clamp Handle
7. Pinon Shaft Handles (3)
8. Table Adjusting Handle

FUNCTIONAL DESCRIPTION

CARTON CONTENTS

1
2
4
MINIMUM gAUgE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Length of
Ampere
Cord in
Rating Volts
0-6 120 up to 25
0-6 120 25-50
0-6 120 50-100
0-6 120 100-150
6-10 120 up to 25
6-10 120 25-50
6-10 120 50-100
6-10 120 100-150
10-12 120 up to 25
10-12 120 25-50
10-12 120 50-100
10-12 120 100-150
12-16 120 up to 25
12-16 120 25-50
12-16 120
GREATER THAN 50 FEET NOT RECOMMENDED
5
6
9
10
11
9. M8x1.25x125mm Carriage Head Screws (2)
8.5mm Flat Washers (2)
8.5mm Lock Washers (2)
M8x1.25 Hex Nuts (2), (for fastening the base to a
supporting surface)
10. Worm Gear for Table Adjusting Mechanism
11. Wrenches (one 3mm and one 5mm)
12. M8 x 1.25 x 25mm Hex Head Cap Screws (4)
13. Chuck Key
6
Total
gauge of Extension
Feet Cord
18 AWg
16 AWg
16 AWg
14 AWg
18 AWg
16 AWg
14 AWg
12 AWg
16 AWg
16 AWg
14 AWg
12 AWg
14 AWg
12 AWg
Fig. D-1
7
8
13
12