Delta DP350 Manual De Instrucciones página 8

3. Insert the raising rack (F) Fig. 4 (removed in STEP 1)
in the groove of the table bracket.
NOTE: Engage the teeth of the worm gear located
inside table bracket with the teeth of the raising rack (F).
4. Slide the raising rack (F) Fig. 5, the table, and table bracket on the drill press column. Place the bottom of the
raising rack (F) Fig. 6 inside the flange (J) on drill press base.
Fig. 5
5. Install the ring (E) Fig. 7 that was removed in STEP 1.
IMPORTANT: DO NOT push the bottom of the ring (E) on the raising rack (F). MAkE SURE that the top of raising rack (F)
is under the bottom of the ring (E) and that enough clearance is available to allow the rack (F) to rotate around the column.
6. Tighten the set screw, but do not over-tighten.
7. Attach the table adjusting handle (K) Fig. 8 to the worm gear shaft (G). Tighten the screw (L) against the flat of the
shaft.
E
D
F
F
Fig. 7
F
F
J
g
Fig. 8
8
Fig. 4
Fig. 6
L
k