DeWalt D28700 Manual De Instrucciones página 8

FIG. 4
FIG. 2
E
Q
DIAMETER OF WORKPIECE
FORWARD
I
F
H
E
SPACER
BLOCK
F
WIDTH OF SPACER BLOCK
Vise Operation (Fig. 4)
The vise (F) has a quick-travel feature. To release the vise when it
is clamped tightly, turn the crank (H) counterclockwise one or two
times to remove clamping pressure. Lift vise lever (I) up. Pull crank
assembly out as far as desired. Vise may be pushed forward into
work without cranking. Lower vise lever (I) then tighten vise (F) on
FIG. 3
work by using crank (H).
Fence Operation
CAUTION: Turn off and unplug the tool before making any
CUT OFF
adjustments or removing or installing attachments or acces-
END
sories. Be sure the trigger switch is in the OFF position.
The fence (E) can be adjusted two ways: to change desired cutting
angle and to change spacing between the fence and vise.
TO CHANGE THE DESIRED CUTTING ANGLE (FIG. 5, 6)
Use the wrench provided to loosen (do not remove) the two
fence bolts (Q). Align the desired angle indicator line with the slot
line (R) in the base (D). Securely tighten both fence bolts before
BLOCK
use.
6