TFK Duo sportkinderwagen Instrucciones De Uso página 10

OPERATING AND ASSEMBLY INSTRUCTIONS
Fig. 1:
To use the tfk duo, fold the pushbar(1) upwards. This will unfold the trolley.
Make sure that the pins (2) audibly engage in the lock. To fold them together,
pull the two locks (2) upwards, they will remain open automatically. You can
then fold the sliding rod (1) forwards. The frame folds in automatically. To
ensure that it remains folded during transport, hook in the transport lock (3).
Fig. 2:
Push the front wheel into the opening provided (4) until it audibly engages. By
turning the adjustment knob (5) you can choose whether the front wheel is
locked in straight-ahead position or can turn freely. If you press the grey
button, you can remove the wheel downwards.
Fig. 3:
To mount the rear wheels, insert the axle into the frame so that the brake is
also in the holder (6). Attach the brake hook (7) in the M-brake. If you wish to
remove the wheels, release the brake hooks (7) and press the kangaroo
button (8) in the middle of the wheel. You can now remove the wheels. You
have the possibility to adjust the braking force by turning the adjusting screw
of the brake hooks (7) in or out and secure them in the chosen position with
the counter screw.
Fig. 4:
The hand brake (9) on the pushbar is both a running and parking brake. To
activate the parking brake, you must pull the brake lever and turn the grey
parking lever (10) so that the brake lever remains fully applied and the brake
is locked permanently. To release the parking brake, pull the brake lever (9)
and release the grey parking lever (10). If the braking effect decreases, you
can make a fine adjustment. To do this, turn the adjusting screw on the brake
lever counterclockwise and check the braking effect again.
Fig. 5:
On the tfk duo air wheel set, you can adjust the directional stability if necessary
using the adjustment wheels (11) located in the wheel receptacle.
Fig. 6:
If you want to use a group-0 seat on the trolley, you must first attach the
adapter to the frame. To do this, bring the adapter frame into position. On the
left in the direction of travel at the bottom and on the right at the top. Close
each of the two clamps (a). Then place the red safety strap around the frame
and secure it with the push button (b).